Honda Fit: Front Brake Hose Replacement
-
Raise and support the vehicle.
-
Remove the front wheel.
-
Disconnect the brake line (A) from the brake hose (B), then remove the brake hose bracket (C).
-
Remove the banjo bolt (A), and disconnect the brake hose (B) from the caliper (C).
-
Remove the brake hose mounting bolt (D), then remove the brake hose.
-
Install the brake hose (A) with the mounting bolt (B).
-
Connect the brake hose to the caliper with the banjo bolt (C) and new sealing washers (D).
-
Install the brake hose bracket (A) to the body, then connect the brake line (B). Do not twist the brake hose.
-
After installing the brake hose, bleed the brake system.
-
Do the following checks:
-
Check the brake hose and line joint for leaks, and tighten if necessary.
-
Check the brake hoses for interference and twisting.
-
-
Clean the mating surfaces between the brake disc and the inside of the wheel, then install the front wheel.
See also:
Transmission Mount Replacement
Do the battery removal procedure.
Remove the air cleaner.
M/T model: Remove the battery cables (A) from the battery terminal fuse
box.
M/T mode ...
Audio
This section describes how to operate the audio system. You can play
music from a wide array of media sources, and control the audio system
using the audio buttons, the touch screen, or voice contro ...
Brake Light, Taillight, Back-Up Light and Rear Turn
Signal Light Bulbs
When replacing, use the following bulbs.
Brake/Taillight: 21/5 W
Back-Up Light: 16 W
Rear Turn Signal Light: 21 W (Amber)
1. Pry on the edge of the cover using a flat-tip
screwdriver to remove ...
Categories
