Push the leg guide cover (A) to release the hook (B), then pull out the cover from the attaching plate (C) and the holder (D) of the leg guide (E).
Remove the nut and bolt, then remove the leg guide (A).
Install the leg guide in the reverse order of removal.
Alternator Brush Inspection
Measure the length of both brushes (A) with a vernier caliper:
If either brush is shorter than the service limit, replace the brushes,
go to step
20.
If brush length ...
Clutch Clearance Inspection (A/T)
Special Tools Required
Clutch Compressor Attachment 07ZAE-PRP0100
Inspect the clutch piston, the discs, the plates, and the end-plate for
wear and damage, and inspect the clutch wav ...
Output Shaft (Countershaft) Speed Sensor Replacement (M/T)
M/T
Raise the vehicle on a lift.
Disconnect the output shaft (countershaft) speed sensor connector (A).
Remove the output shaft (countershaft) speed sensor (B).
...