Honda Fit manuals

Honda Fit: Rear Seat Control Cable Replacement

NOTE:

  1. Remove the rear seat assembly.

  1. Remove the rear seat cushion.

  1. Remove the rear seat cushion cover/pad and the silencer.

  1. Fold the leg, and remove the wire tie (A).

  2. ABCDBB
  3. Disconnect the control cable (B) from the leg end (C) and cable bracket (D) of the seat cushion frame.

  4. Install the cable in the reverse order of removal, and note these items:

    • Replace the wire tie you removed with a new one.

    • Make sure the control cable is routed properly and connected securely.

    • Install the new cable end in the same position as the original cable end. Check the rear seat for proper tip-up operation. If necessary, adjust the position of the cable end and recheck.

See also:

Safety of Larger Children
WARNING Allowing a child age 12 or under to sit in front can result in injury or death if the passenger’s front airbag inflates. If a larger child must ride in front, move the vehicle seat as ...

Driver's Seat Position Sensor Replacement
Removal NOTE: Do not turn the ignition switch to ON (II), and do not connect the battery cable while removing the driver's seat position sensor. Do the battery terminal disconnection ...

Protecting Your Discs
General Information • When using CD-R or CD-RW discs, use only high quality discs labeled for audio use. • When recording a CD-R or CD-RW, the recording must be closed for it to be used by t ...

© 2026 Copyright www.hfitinfo.com