Honda Fit: Front Seat-Back Cover/Pad Replacement (Part - 2)
-
Release airbag attachment wire A and airbag attachment wire B from the seat-back frame (C).
-
Passenger's seat: Remove the ODS unit cover (A).
-
Turn over the seat-back cover (B) and the pad (C) as needed.
-
Release the cover from the lower hooks (D).
-
Pull the cover upward to release it from the upper hook (E).
-
-
Passenger's seat: Disconnect the ODS unit harness connector (F) and the OPDS sensor connectors (G).
-
Passenger's seat: Detach the harness clips (A) fastening the OPDS sensor harnesses (B) and the ODS unit harness (C).
-
Passenger's seat: Pull out the side airbag harness (A) and the ODS unit harness (B) through the holes (C) in the seat-back pad (D) and the seat-back cover (E).
See also:
If the Engine Overheats
The high temperature indicator should be off under most conditions.
If the engine coolant temperature gets higher than normal, the indicator will
blink. If it stays on, you should determine the rea ...
PCV Valve Replacement
Remove the harness holder (A).
Disconnect the hose (A).
Remove the PCV valve (B).
Install the parts in the reverse order of removal with a new 14 mm washe ...
A/T Housing Reverse Idler Gear Installation (A/T)
Lightly coat the reverse idler gear shaft (A), the needle bearing (B),
and new O-rings (C) with lithium grease.
Assemble the new O-rings and the needle bearing on the reverse ...
Categories
