Honda Fit: Side

See also:

Installation
Install the damper rubber mount (A) onto the damper unit. Position the damper assembly (B) between the body and the axle beam. NOTE: Be careful not to damage the body. ...

Driveshaft Installatio
NOTE: Before starting installation, make sure the mating surfaces of the joint and the splined section are clean. Apply about 5 g (0.18 oz) moly 60 paste (P/N 08734-0001) to the contact ar ...

Secondary HO2S Replacement
Special Tools Required O2 Sensor Wrench Snap-on S6176 or equivalent, commercially available Disconnect the secondary HO2S connector (A). Raise the vehicle on a lift. ...