Honda Fit: Power Mirror Switch Test/Replacement
-
Remove the instrument panel.
-
Disconnect the 13P connector from the power mirror switch (A).
-
Check for continuity between the terminals in each switch position according to the table.
-
If the continuity is not as specified, remove the screws and the covers and replacement the power mirror switch.
-
Install in the reverse order of removal.
Power Mirror Switch
See also:
Immobilizer System Description
The vehicle is equipped with a Type VII immobilizer system that disables the
vehicle unless a programmed ignition key is used.
This system consists of a transponder combined with a keyless transmit ...
Alternator Disassembly (Page -3)
Install a new front bearing in the drive-end housing with a hammer, the driver
handle, 15 x 135L (A), and the bearing driver attachment, 42 x 47 mm (B).
@fo ...
Air Cleaner Removal/Installation
Disconnect the MAF sensor/IAT sensor connector(A), then remove the air
cleaner cover (B) and the air cleaner element (C).
NOTE: Be careful not to damage the MAF sensor/IAT sensor on the air ...
Categories
