Honda Fit: Panels

See also:

Countershaft Inspection (M/T)
Inspect the gear and bearing contact areas for wear and damage, then measure the countershaft at points A, B, and C. If any part of the countershaft is less than the service limit, replace ...

Glove Box Striker Replacement
SRS components are located in this area. Review the SRS component locations   and the precautions and procedures   before doing repairs or service. NOTE: Take care not to scra ...

A/T Housing Idler Gear Shaft Removal and Installation (A/T)
Remove the snap ring (A), the cotter retainer (B), and the cotters (C) from the idler gear shaft (D), then remove the idler gear shaft. Do not distort the snap ring. Check ...