Canada Models Without Front Fog Lights
NOTE:
Put on gloves to protect your hands.
Take care not to scratch the front bumper.
Remove the front bumper.
Remove the clips and the hooks (A), then remove the lower front bumper grille cover (B) from the front bumper (C).
NOTE: To release the clips, pry up on the center pin at the notch (D).
Install the cover in the reverse order of removal, and note these items:
If the clips are damaged or stress-whitened, and replace them with new ones.
Push the clips and the hooks into place securely.
Fuel Pump/Fuel Gauge Sending Unit Replacement
Remove the fuel tank unit.
Remove the fuel level sensor (fuel sending unit) (A) from the fuel tank
unit (B).
Check these items before installing the fuel tank ...
System Initialization
The navigation system must be initialized if
power to the navigation system is
interrupted for any reason (e.g., the
battery was disconnected). ...
Driveshaft Installatio
NOTE: Before starting installation, make sure the mating surfaces of the
joint and the splined section are clean.
Apply about 5 g (0.18 oz) moly 60 paste (P/N 08734-0001) to the contact
ar ...