Honda Fit: Voice Control Switch Replacement (With Navigation)
SRS components are located in this area. Review the SRS component location, and the precautions and procedures in the SRS section before doing repairs or service.
-
Remove the steering wheel.
-
Remove the audio remote switch.
-
Remove the switch cover (A) from the HFL-navigation voice control switch (B).
-
Remove the screws (A), and remove the set plate (B).
-
Remove the screws (C), and remove the HFL-navigation voice control switch (D).
-
Install the voice control switch in the reverse order of removal.
See also:
M/T Differential Thrust Clearance Adjustment (M/T)
Special Tools Required
Driver Handle, 40 mm I.D. 07746-0030100
Remove the left driveshaft side oil seal from the transmission housing.
If you remove the 80 mm shim (A) fro ...
Engine Oil Filter Feed Pipe Replacement
Remove the filter.
Remove the oil filter feed pipe.
Install two 20 x 1.5 mm nuts (A) onto the new oil filter feed pipe, and
hold one nut with a wrench, then ti ...
Piston Installation
If the Crankshaft is Already Installed
Set the crankshaft to bottom dead center (BDC) for each cylinder as its
piston is installed.
Remove the connecting rod caps, and check that ...
Categories
