Alternator Reassembly
If you removed the pulley, put the rotor in the drive-end housing, then torque
its locknut to 110 N·m (11.2 kgf·m, 81 lbf·ft).
Remove any grease or any oil from the ...
A/T Housing Idler Gear Shaft Removal and Installation (A/T)
Remove the snap ring (A), the cotter retainer (B), and the cotters (C)
from the idler gear shaft (D), then remove the idler gear shaft. Do not
distort the snap ring.
Check ...
Airbag and Tensioner Disposal
Special Tools Required
Deployment Tool 07AAZ-000A100
Before scrapping any airbags, side airbags, side curtain airbags, seat belt
tensioners (including those in a whole vehicle to be scrapped) ...