
■ Reasons for the indicator to come on
• Comes on when there is a problem with EPS system.
• If you depress the accelerator pedal repeatedly to increase the engine speed while the engine is idling, the indicator comes on, and sometimes the steering wheel becomes harder to operate.
■ What to do when the indicator comes on
Stop the vehicle in a safe place and restart the engine.
If the indicator comes on and stays on, immediately have your vehicle inspected by a dealer.
NOTICE
If you repeatedly turn the steering wheel at an extremely low speed, or hold the steering wheel on the full left or right position for a while, the system heats up. The system goes into a protective mode, and limits its performance. The steering wheel becomes harder and harder to operate. Once the system cools down, EPS system is restored. Repeated operation under these conditions can eventually damage the system.
Cylinder Head Installation
Clean the cylinder head and the engine block surface.
Install a new coolant separator (A) in the engine block whenever the
engine block is replaced.
Install a new ...
Startup Confirmation Screen
The Startup Confirmation screen is
displayed when initialization has
successfully completed. It is displayed every
time you start your vehicle. Select OK to
continue.
NOTE:
“OK” cannot be ...
Radiator Replacement
Raise the vehicle on the lift.
Drain the engine coolant.
Disconnect the ECT sensor 2 connector (A), then remove the harness clamp
(B).
With A/C: Re ...