Honda Fit: Wear Indicators
The groove where the wear indicator is located is 1/16 inch (1.6 mm) shallower than elsewhere on the tire. If the tread has worn so that the indicator is exposed, replace the tire.
Worn out tires have poor traction on wet roads.
See also:
Piston Installation
If the Crankshaft is Already Installed
Set the crankshaft to bottom dead center (BDC) for each cylinder as its
piston is installed.
Remove the connecting rod caps, and check that ...
Engine Compression Inspection
NOTE: After the inspection, you must reset the ECM/PCM. Otherwise, the
ECM/PCM will continue to stop the injectors from operating.
Allow the engine to reach operating temperature (fan comes o ...
Clutch Replacement (M/T)
Special Tools Required
Clutch Alignment Disc 07JAF-PM7011A
Clutch Alignment Shaft 07JAF-PM7012A
Clutch Alignment Shaft 07ZAF-PR8A100
Ring Gear Holder 07LAB-PV00100
Weight, Remover 07741-0010 ...
Categories
