Honda Fit: Torque Converter Housing Selector Control Shaft Oil Seal Replacement (A/T)
Special Tools Required
- Driver Handle, 15 x 135L 07749-0010000
- Oil Seal Driver Attachment 07947-ZV00100
-
Remove the oil seal from the torque converter housing.
-
Install the new oil seal (A) in the torque converter housing to a depth (B) of 0.5пјЌ1.5 mm (0.02пјЌ0.06 in) below the housing surface using the driver handle and the oil seal driver attachment.
See also:
Driveshaft Disassembly
Special Tools Required
Threaded Adapter, 22 x 1.5 mm 07XAC-001010A
Slide Hammer 5/8''-18 UNF, commercially available
Bearing Puller, commercially available
Boot Band Pliers, commerci ...
Locking/Unlocking the Doors from the Outside
Using the Remote Transmitter*
■ Locking the doors
Press the lock button.
Once:
►Some exterior lights flash, all the doors
and tailgate lock, and the security system
sets.
Twic ...
Address Calculation
The destination icon shows only the
approximate location of a destination
address. This occurs if the number of
possible addresses is different from the
number of actual addresses on a block. For
...
Categories
