Honda Fit manuals

Honda Fit: Transmission End Cover Park Lever Stop Inspection and Adjustment (A/T)

  1. Set the park lever in the P position.

  1. Measure the center-to-center distance (A) between the park pawl shaft (B) and the park lever roller pin (C).

    Standard:

    37.8пјЌ38.8 mm (1.49пјЌ1.53 in)

  1. If the measurement is out of standard, select and install the appropriate park lever stop (A) from the table.

PARK LEVER STOP

Mark

B

C

1

11.00 mm
(0.433 in)

11.00 mm
(0.433 in)

2

10.80 mm
(0.425 in)

10.65 mm
(0.419 in)

3

10.60 mm
(0.417 in)

10.30 mm
(0.406 in)

  1. After replacing the park lever stop, make sure the distance is within tolerance.

See also:

Auxiliary Input Jack
Use the jack to connect standard audio devices. 1. Open the AUX cover. 2. Connect a standard audio device to the input jack using a 1/8 inch (3.5 mm) stereo miniplug. ► The audio system a ...

Torque Converter Housing Selector Control Shaft Oil Seal Replacement (A/T)
Special Tools Required Driver Handle, 15 x 135L 07749-0010000 Oil Seal Driver Attachment 07947-ZV00100 Remove the oil seal from the torque converter housing. Install the n ...

Steering Wheel Installation
SRS components are located in this area. Review the SRS component locations, and the precautions and procedures   before doing repairs or service. Before installing the steering ...

© 2026 Copyright www.hfitinfo.com