Honda Fit: MAF Sensor/IAT Sensor Replacement
-
Disconnect the MAF sensor/IAT sensor connector (A).
-
Remove the screws (B).
-
Remove the MAF sensor/IAT sensor (C).
-
Install the parts in the reverse order of removal with a new gasket (D).
See also:
Wear Indicators
The groove where the wear indicator is
located is 1/16 inch (1.6 mm) shallower than
elsewhere on the tire. If the tread has worn so
that the indicator is exposed, replace the tire.
Worn out ti ...
Installation
Hold the gearbox housing using a C-clamp (A) and wooden blocks (B) to a
workbench as shown. Do not clamp the cylinder part of the gearbox housing in
a vise.
...
Low Oil Pressure Indicator
This indicator should never come on when the engine is running. If it starts
flashing or stays on, the oil pressure has dropped very low or lost pressure. Serious
engine damage is possible, and ...
Categories
