NOTE:
When installing the drain bolt (A), always use a new washer.
When installing the sealing bolt(s) (B), always use a new bolt(s) and washer(s) (C).

Removal (Part -2)
Remove the harness clamp (A) from its clamp bracket (B) located in front
of the left damper top.
@font-face{font-family:
"Honda_SymbolMarkeng";src:url(/st ...
Wear Indicators
The groove where the wear indicator is
located is 1/16 inch (1.6 mm) shallower than
elsewhere on the tire. If the tread has worn so
that the indicator is exposed, replace the tire.
Worn out ti ...
Transmission Side - Release Bearing Removal
Remove the transmission.
Remove the release fork boot (A) from the clutch housing (B).
Squeeze the release fork set spring (C) with pliers to remove the release
...