Honda Fit manuals

Honda Fit: Connecting Rod Bolt Inspection

  1. Measure the diameter of each connecting rod bolt at point A and point B with a micrometer.

  1. Calculate the difference in diameter between point A and point B.

    Point AпјЌPoint B = Difference in Diameter

    Difference in Diameter

    Specification:

    0пјЌ0.05 mm (0пјЌ0.0020 in)

  2. If the difference in diameter is out of tolerance, replace the connecting rod bolt.

See also:

Fuel Pressure Relieving
Before disconnecting fuel lines or hoses, relieve pressure from the system by disabling the fuel pump and disconnecting the fuel line/quick connect fitting in the engine compartment. With the HDS ...

Find Place Commands
Find nearest (specify place): Auto service center ACURA dealers HONDA dealers Gas station Hydrogen station Auto parts & electronics shop Auto repair & maintenance shop Car wash & d ...

Output Shaft (Countershaft) Speed Sensor Replacement (A/T)
Remove the air cleaner assembly. Disconnect the output shaft (countershaft) speed sensor connector, and remove the output shaft (countershaft) speed sensor (A). ...

© 2026 Copyright www.hfitinfo.com