Release the parking brake lever fully.
Remove the center console.
Disconnect the parking brake switch connector (A) from the parking brake switch (B).
Remove the parking brake lever mounting bolts (C).
Disconnect the parking brake cables (D) from the equalizer (E).
Remove the parking brake switch.
Install the parking brake lever in the reverse order of removal.
Adjust the parking brake.
Alternator Reassembly
If you removed the pulley, put the rotor in the drive-end housing, then torque
its locknut to 110 N·m (11.2 kgf·m, 81 lbf·ft).
Remove any grease or any oil from the ...
VSA® (Vehicle Stability Assist), aka ESC (Electronic Stability Control),
System
VSA® helps to stabilize the vehicle during cornering if the vehicle turns
more or less
than what was intended. It also assists in maintaining traction on slippery
surfaces.
It does so by regu ...
Alternator Brush Inspection
Measure the length of both brushes (A) with a vernier caliper:
If either brush is shorter than the service limit, replace the brushes,
go to step
20.
If brush length ...