Honda Fit manuals

Honda Fit: Disassembly

  1. Raise and support the vehicle.

  1. Remove the rear wheels.

  1. Release the parking brake, and remove the brake drum.

  1. Remove the tension pins (A) by pushing respective retainer spring (B) and turning the pin.

  2. ABBA
  1. Remove the lower return spring (A), and remove the brake shoe assembly over the hub.

  2. DEBAC
  3. Remove the forward brake shoe (B) by removing the upper return spring (C), and disassemble the brake shoe assembly.

  4. Remove the rearward brake shoe (D) by disconnecting the parking brake cable from the parking brake lever (E).

  1. Remove the U-clip (A), the wave washer (B), and the pivot pin (C), and separate the parking brake lever (D) from the brake shoe (E).

  2. ADEBC
See also:

Starting the Engine
1. Make sure the parking brake is applied. Automatic transmission models 2. Check that the shift lever is in , then depress the brake pedal. ► Although it is possible to start the vehic ...

Breather Line and Suction Line Inspection (Page-1)
Special Tools Required Fuel Pressure Gauge Attachment Set 07AAJ-S6MA150 Vacuum Pump/Gauge, 0-30 inHg Snap-on YA4000A or equivalent, commercially available Vacuum/Pressure Gauge, 0-4 inHg 07 ...

Models with 7 positions AT Shifting
Change the shift position in accordance with your driving needs. ■ Shift lever positions You cannot turn the ignition switch to LOCK and remove the key unless the shift lever is in . ...

© 2026 Copyright www.hfitinfo.com