Honda Fit manuals

Honda Fit: Inspection

  1. Raise and support the vehicle.

  1. Remove the front wheels.

  1. Check the thickness (A) of the inner pad (B) and the outer pad (C). Do not include the thickness of the backing plate.

    Brake pad thickness:

    Standard:

    10.0 mm (0.394 in)

    Service limit:

    1.6 mm (0.063 in)

  2. Inner pad

    AB

    Outer pad

    AC
  3. If any part of the brake pad thickness is less than the service limit, replace the front brake pads as a set.

  4. Clean the mating surfaces between the brake disc and the inside of the wheel, then install the front wheels.


See also:

Operation in Alaska, Hawaii, Canada, and Puerto Rico
Map Coverage All roads displayed on the map screens are verified roads. Information in this manual relating to “unverified” roads or areas is not applicable. Address and Place Entry Screens ...

Security System Alarm
The security system alarm activates when the doors, tailgate, or hood are opened without the key, or remote transmitter. ■ When the security system alarm activates The horn sounds intermitt ...

Voice Control Switch Replacement (With Navigation)
SRS components are located in this area. Review the SRS component location, and the precautions and procedures   in the SRS section before doing repairs or service. Remove the ...

© 2026 Copyright www.hfitinfo.com