Honda Fit manuals

Honda Fit: Front Passenger's Weight Sensor Replacement (Part-2)

  1. When tightening the TORX nuts (A), begin with ?, and tighten them in a crisscross pattern in two or more steps.

  2. BBA43 Nح (4.4 kgfح, 32 lbfئt)CA43 Nح (4.4 kgfح, 32 lbfئt)????
  3. Connect the front passenger's weight sensor connectors (B).

    NOTE: The sensor connectors with the white tape (C) connect to the front sensors.

  4. Reassemble the front passenger's seat cushion cover/pad.

  5. Reinstall the front passenger's seat.

  6. Do the battery terminal reconnection procedure.

  7. Clear any DTCs with the HDS.

  8. Do the front passenger's weight sensor initialization.

  9. Confirm proper SRS operation: Turn the ignition switch to ON (II), and check that the SRS indicator comes on for about 6 seconds and then goes off.

See also:

Pilot Bearing Replacement
Remove the crankshaft pilot bearing (A) using the remover weight (B), and the 15 mm bearing remover shaft set (C). Install a new pilot bearing (A) into the crankshaft using th ...

Rear Inner Fender Replacement
NOTE: Put on gloves to protect your hands. Take care not to scratch the body. Remove the screws (A) and the clips (B, C), then remove the rear inner fender (D). NOTE: T ...

Obtaining Navigation Update Data
Honda is continually expanding the scope of the navigation system. Navigation system software upgrades may be made available periodically, usually in the fall of each year. To purchase an updat ...

© 2026 Copyright www.hfitinfo.com