Honda Fit manuals

Honda Fit: Side Impact Sensor (Second) Replacement

Removal

  1. Do the battery terminal disconnection procedure, then wait at least 3 minutes before starting work.

  1. Remove the cargo area side trim.

  1. Disconnect the side impact sensor (second) 2P connector (A) on the floor wire harness.

  2. BAC
  3. Remove the TORX bolt (B) using a TORX T30 bit, then remove the side impact sensor (second) (C).

Installation

  1. Install the side impact sensor (second) (A) with a new TORX bolt (B), using a TORX T30 bit. Connect the side impact sensor (second) 2P connector (C) on the floor wire harness.

  2. CB11 Nح (1.1 kgfح, 8.1 lbfئt)Replace.A
  3. Do the battery terminal reconnection procedure.

  4. Clear any DTCs with the HDS.

  5. Confirm proper SRS operation: Turn the ignition switch to ON (II) , and check that the SRS indicator comes on for about 6 seconds, and then goes off.

  6. Reinstall all removed parts.

See also:

Numbers
...

M/T Differential Thrust Clearance Adjustment (M/T)
Special Tools Required Driver Handle, 40 mm I.D. 07746-0030100 Remove the left driveshaft side oil seal from the transmission housing. If you remove the 80 mm shim (A) from ...

Tire Pressure Monitoring System (TPMS) - Required Federal Explanation
U.S. models Each tire, including the spare (if provided), should be checked monthly when cold and inflated to the inflation pressure recommended by the vehicle manufacturer on the vehicle placard o ...

© 2026 Copyright www.hfitinfo.com