Honda Fit: Grab Handle Removal/Installation
Special Tools Required
- KTC Trim Tool Set SOJATP2014
*Available through the Acura Tool and Equipment Program; call 888-424-6857
NOTE: Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
-
Lower the grab handle (A), then insert a small flat-tip screwdriver wrapped in protective tape into the notch.
-
Use a KTC trim tool (A) to pull on the small flat-tip screwdriver, and remove the cap (B).
-
Pinch the clips (A) to release the hooks (B), then remove the grab handle (C).
-
Remove the clips (A) by pinching the hooks with a pair of pliers.
-
If the side curtain airbag has deployed, replace the grab handle, along with the other parts listed for side curtain airbag deployment.
-
If the side curtain airbag has not deployed, inspect the grab handle for damage. A damaged grab handle may cause the side curtain airbag to deploy improperly, possibly causing injury. Replace the grab handle if it has any of the following damage:
-
Any cracks or damage in the grab handle (A).
-
Any cracks or stress-whitening in the caps (B).
-
-
Install the clips (A) on the grab handle (B), then insert the caps (C) fully into the clips.
-
Position the grab handle (A) on the mounting bracket (B), and push on the grab handle until the clips (C) snap into place securely.
See also:
Cruise Control
On Sport model and Canadian LX model
Cruise control allows you to maintain a set speed above 25 mph (40 km/h) without
keeping your foot on the accelerator pedal. It should be used for cruising on s ...
Audio Screen Control
AUDIO button (in iPod® mode)
Control the audio screen through the navigation system.
Select a track.
Select the menu tab to change
songs in the track list.
The following items are ava ...
HFL Menus
The ignition switch must be in ACCESSORY
or ON
to use HFL.
To use HFL, you must first pair your Bluetooth-compatible cell phone to the
system while the vehicle is parked.
Phone Setup
&# ...
Categories
