Honda Fit: Passenger's Power Window Switch Replacement
NOTE: The illustration shows front passenger's power window switch.
-
Remove the door panel:
-
Front passenger's
-
Rear
-
-
Remove the screws and the grip base (A).
-
Open the switch panel (A) from the grip base.
-
Remove the screws and replace the passenger's power window switch (B).
-
Install the parts in the reverse order of removal.
See also:
Refilling Window Washer Fluid
Models without washer level sensor
Check the amount of window washer fluid. Look for 1/2 mark on the reservoir.
If the level is low, fill the washer reservoir.
Models with washer level senso
If ...
Output Shaft (Countershaft) Speed Sensor Replacement (M/T)
M/T
Raise the vehicle on a lift.
Disconnect the output shaft (countershaft) speed sensor connector (A).
Remove the output shaft (countershaft) speed sensor (B).
...
Installation (Part -3)
Remove the vinyl tape from the connectors.
Connect the EPS motor angle sensor 8P connector (A), torque sensor 6P connector (B) to the steering gearbox.
...
Categories
