Honda Fit: Subframe Replacement
Front Subframe Torque
NOTE:
-
After loosening the subframe mounting bolts, be sure to replace them with new ones.
-
Loosely install new front subframe mounting bolts, then tighten the bolts to the specified torque in the sequence shown.
-
Tighten the new front subframe mounting bolts in the numbered sequence shown.
See also:
Secondary Shaft 2nd Gear Axial Clearance Inspection (A/T)
Install the thrust needle bearing (A), the needle bearing (B), 2nd gear
(C), the thrust needle bearing (D), the 43 x 54.5 mm thrust washer (E), the
39 mm cotters (F), and the cotter retain ...
Transmission Housing Bearing Installation (A/T)
Special Tools Required
Bearing Driver Attachment, 72 x 75 mm 07746-0010600
Bearing Driver Attachment, 78 x 80 mm 07NAD-PX40100
Bearing Driver Attachment, 62 x 68 mm 07746-0010500
Driver Handle ...
Immobilizer System
The immobilizer system prevents a key that has not been pre-registered from
starting the engine. Each key contains electronic transmitters that use
electronic
signals to verify the key.
Pay att ...
Categories
