Remove the front individual map light lens (A) using a flat-tip screwdriver.
Remove the bolts (B), then disconnect the connectors, and remove the map light housing (C).
Carefully pry off the microphone housing (D) from the map light housing while pressing the retaining tabs (E).
Install the microphone in the reverse order removal.
PIN Numbers
INFO button
► Setup
►Personal Information►PIN Number
Set a 4-digit PIN for protecting personal addresses and your home addresses.
Once
you set a PIN, you are prompted to ente ...
Warm Up TWC Removal/Installation
NOTE: If the warm up TWC is damaged internally, inspect the under-floor TWC
for debris.
Raise the vehicle on a lift.
Remove the bolts (A).
Lower the vehicle.
...
Starting the Engine
1. Apply the parking brake.
2. In cold weather, turn off all
electrical accessories to reduce the drain on the battery.
3. Manual transmission:
Press the clutch pedal down all the way. The START ( ...