Honda Fit: System Limitations

See also:

Alternator Reassembly
If you removed the pulley, put the rotor in the drive-end housing, then torque its locknut to 110 N·m (11.2 kgf·m,   81 lbf·ft). Remove any grease or any oil from the ...

Driving to Your Destination
This section describes how to follow the route guidance to your destination, and choose the icons displayed on the map screen. ...

A/T Differential Backlash Inspection (A/T)
Install the driveshaft and intermediate shaft into the differential assembly, and place the axles on V-blocks   (A). Measure the backlash of the pinion gears (B) wit ...