Honda Fit: Phone Setup
PHONE button
► Phone Setup
Set HFL options and features.
1. Select an item.
2. Select OK.
The following items are available:
• Bluetooth Setup
: Pairs your phone to the system.
• Bluetooth Connection:
Turns the Bluetooth® connection on or off.
On
: Connects your Bluetooth-compatible device to the system.
Off
(factory default): Disables the feature.
• Auto
Transfer
: Sets whether to automatically transfer a call from your phone to HFL when you enter and turn on the vehicle.
On
(factory default): Automatically transfers your call to HFL.
Off
: Disables the feature.
• Auto
Answer
: Sets whether to automatically answer an incoming call.
On
: Automatically connects an incoming call after about five seconds.
Off
(factory default): Disables the feature.
• Volume
: Select 
or
to adjust the receiver and ring
volume. If you change
the volume during a call, it is maintained at that level until you change it
again.
You can control the HFL system using voice commands.
See also:
Shifter Input and Linkage
Paddle Shifter (Downshift Switch) Replacement (A/T)
SRS components are located in this area. Review the SRS component locations
and the precautions and procedures before doi ...
CKP Sensor Replacement
Raise the vehicle on a lift.
NOTE: Make sure the vehicle is level, because engine oil will drip out
when you remove the sensor.
Loosen the bolt (A). Remove the bolt (B) and ...
Safety Labels
These labels are in the locations shown. They warn you of potential hazards that
could cause serious injury or death. Read these labels carefully.
If a label comes off or becomes hard to read (exce ...
Categories
