The system is disabled when it is disconnected from the power source, such as when the battery is disconnected or goes dead.
■ Reactivating the system
1. Turn the ignition switch to ON (II), and turn on the system.
► If you turn the ignition switch to ACCESSORY (I), you will be requested to enter the security code. See step 3.
2. Press and hold the VOL
(Volume/Power) button again for more than two
seconds.
► The system is reactivated when the system’s control unit recognizes that the system is in your vehicle.
► If the control unit fails to recognize, “ENTER CODE” appears on the navigation screen.
3. Enter the security code. If you do not enter the code correctly after 10 tries, leave the system for one hour before trying again, or visit a dealer to have the system reset.
Find the audio system’s security code and serial number label in your Owner’s Manual kit.
Do not store the label in your vehicle. If you lose the label, you must first retrieve the serial number, and then obtain the code from a dealer.
U.S. Only
You can register the security code at Owner Link (owners.honda.com.). To find information on how to retrieve the serial number and obtain the code, visit radio-navicode.honda.com.
Ball Joint Boot Inspection/Replacement
Special Tools Required
Bearing Driver Attachment, 40 mm 07GAF-SE00200
Check the ball joint boot for weakness, damage, cracks, and grease leaks.
NOTE:
If the ball joint boot is ...
Pairing from Phone Setup
PHONE button
► Phone Setup
Use the Phone setup screen to pair an additional Bluetooth-compatible phone
if a
phone has been previously paired to the system.
1. Select Add/Select a Phone ...
Fuel Pressure Relieving
Before disconnecting fuel lines or hoses, relieve pressure from the system by
disabling the fuel pump and disconnecting the fuel line/quick connect fitting in
the engine compartment.
With the HDS ...