NOTE: The park pin switch is installed in the shift lever bracket base, and not available separately from the shift lever bracket base; replace the park pin switch and the shift lever bracket base as an assembly.
Remove the shift lever.
Disassemble the shift lever.
Replace the park pin switch and the shift lever bracket base assembly.
Assemble the shift lever.
Install the shift lever.
Wheel Runout Inspection
Raise and support the vehicle.
Check for a bent or deformed wheel.
Set up the dial gauge as shown, and measure the axial runout by turning
the wheel.
...
As required by the FCC
1)This device complies with Part 15 of the
FCC Rules and Canadian RSS-210/RSSGen.
Operation is subject to the following
two conditions: (1) this device may not
cause harmful interference, and (2 ...
Rear Brake Hose Replacement
Raise and support the vehicle.
Remove the rear wheel.
Disconnect the brake hose (A) from the brake line (B) using a 10 mm flare-nut
wrench (C).
...