Honda Fit manuals

Honda Fit: Rear Seat Control Cable Replacement

NOTE:

  1. Remove the rear seat assembly.

  1. Remove the rear seat cushion.

  1. Remove the rear seat cushion cover/pad and the silencer.

  1. Fold the leg, and remove the wire tie (A).

  2. ABCDBB
  3. Disconnect the control cable (B) from the leg end (C) and cable bracket (D) of the seat cushion frame.

  4. Install the cable in the reverse order of removal, and note these items:

    • Replace the wire tie you removed with a new one.

    • Make sure the control cable is routed properly and connected securely.

    • Install the new cable end in the same position as the original cable end. Check the rear seat for proper tip-up operation. If necessary, adjust the position of the cable end and recheck.

See also:

Safety Labels
Label Locations These labels are in the locations shown. They warn you of potential hazards that can cause serious injury or death. Read these labels carefully. If a label comes off o ...

Radio Theft Protection
Your vehicle’s audio system will disable itself if it is disconnected from electrical power for any reason. To make it work again, you must enter a specific five-digit code in the preset button ...

Carbon Monoxide Hazard
Your vehicle’s exhaust contains carbon monoxide gas. Carbon monoxide should not enter the vehicle in normal driving if you maintain your vehicle properly and follow the information on this page. ...

© 2026 Copyright www.hfitinfo.com