The high beam headlights come on slightly dimmer than normal when the
following
conditions have been met:
• The ignition switch is in ON
.
• The headlight switch is off, or in .
• The parking brake is released.
The lights remain on even if you set the parking brake. Turning off the ignition switch will turn off the daytime running lights.
The high beam headlights return to the original brightness once the headlight switch is turned on.
Audio Antenna
Your vehicle is equipped with a removable
antenna at the rear of the roof.
NOTICE
Before using a “drive-through” car wash, remove the
antenna by unscrewing it by hand. This prevents the
ant ...
Installation
Install ECT sensor 1 (A) with a new O-ring (B).
Install the water bypass hose (C).
Remove all of the old liquid gasket from the water outlet mating
surfaces, the bolts ...
Intermediate Shaft Reassembly (A/T)
Exploded View
Special Tools Required
Oil Seal Driver, 65 mm 07JAD-PL90100
Bearing Driver Attachment, 52 x 55 mm 07746-0010400
Bearing Driver Attachment, 35 mm I.D. 07746-0030400
Drive ...