Honda Fit: Horn Test/Replacement
'09-11 models
-
Remove the front grille cover.
-
Disconnect the 1P connector (A) from the horn (B).
-
Connect the terminal (A) to battery power, and the bracket (B) to body ground.
-
If the horn does not sound, replace it.
'12-13 models
-
Remove the front grille cover.
-
Disconnect the 1P connector (A) from the horn (B).
-
Connect the terminal (A) to battery power, and the bracket (B) to body ground.
-
If the horn does not sound, replace it.
See also:
A/T Housing Idler Gear Shaft Removal and Installation (A/T)
Remove the snap ring (A), the cotter retainer (B), and the cotters (C)
from the idler gear shaft (D), then remove the idler gear shaft. Do not
distort the snap ring.
Check ...
Brake Light, Taillight, Back-Up Light and Rear Turn
Signal Light Bulbs
When replacing, use the following bulbs.
Brake/Taillight: 21/5 W
Back-Up Light: 16 W
Rear Turn Signal Light: 21 W (Amber)
1. Pry on the edge of the cover using a flat-tip
screwdriver to remove ...
Servo Body Disassembly, Inspection, and Reassembly (A/T)
Clean all parts thoroughly in solvent, and dry them with compressed air.
Blow out all passages.
Inspect the servo body for scoring and damage.
Check all valves for fre ...
Categories
