Honda Fit: Flywheel Inspection
-
Remove the ring gear holder.
-
Inspect the ring gear teeth for wear and damage.
-
Inspect the clutch disc mating surface on the flywheel for wear, cracks, and burning.
-
Measure the flywheel (A) runout using a dial indicator (B). Through at least two full turns with pushing against the flywheel each time you turn it to take up the crankshaft thrust washer clearance. If the measurement is more than the service limit, replace the flywheel, and recheck the runout. Go to step 16.
Standard (New):
0.05 mm (0.0020 in) max.
Service Limit:
0.15 mm (0.0059 in)
See also:
About Your Seat Belts
Seat belts are the single most effective safety device because they keep you
connected to the vehicle so that you can take advantage of many built-in safety
features. They also help keep you from be ...
Secondary Shaft 2nd Gear Axial Clearance Inspection (A/T)
Install the thrust needle bearing (A), the needle bearing (B), 2nd gear
(C), the thrust needle bearing (D), the 43 x 54.5 mm thrust washer (E), the
39 mm cotters (F), and the cotter retain ...
Storing Your Home Address
1 Press the INFO button.
2 Select Setup.
3 Select Personal Information.
4 Select Home Address 1.
5 Select Edit Name.
6 Enter a name and select OK.
7 Select Edit Address.
8 Select ...
Categories
