Honda Fit: Change Lever Clearance Inspection (M/T)
-
Measure the clearance between the change lever (A) and the select lever (B) with a feeler gauge (C). If the clearance is more than the service limit, go to step 2.
Standard:
0.05пјЌ0.35 mm (0.002пјЌ0.013 in)
Service Limit:
0.55 mm (0.021 in)
-
Measure the groove width of the change lever.
-
If the groove width is not within the standard, replace the change lever.
-
If the groove width is within the standard, replace the select lever.
Standard:
13.00пјЌ13.15 mm (0.5118пјЌ0.5177 in)
-
See also:
PIN Numbers
INFO button
► Setup
►Personal Information►PIN Number
Set a 4-digit PIN for protecting personal addresses and your home addresses.
Once
you set a PIN, you are prompted to ente ...
Protecting Child Passengers
Each year, many children are injured or killed in vehicle crashes because
they are
either unrestrained or not properly restrained. In fact, vehicle accidents are
the
number one cause of death of ...
Mainshaft Thrust Clearance Adjustment (M/T)
Special Tools Required
Mainshaft Base 07GAJ-PG20130
Collar 07GAJ-PG20120
Mainshaft Holder 07GAJ-PG20110
Remove the 72 mm shim (A) and oil guide plate M from the transmission
housing ...
Categories
