Remove the ATF feed pipe (A) from the regulator valve body (B).
Remove the ATF feed pipes (C) (D) from the servo body (E).
Remove the ATF strainer (F) (two bolts).
Unhook the detent spring (G) from the detent arm (H), and remove the control shaft (I).
Remove the regulator valve body (10 bolts).
Remove the stator shaft (J) and stator shaft stop (K), then remove the regulator separator plate (L) and two dowel pins (M).
Remove the servo body (11 bolts), then remove the separator plate (N) and two dowel pins (O).
Remove the ATF joint pipes (P) (Q).
Remove the cooler check valve spring (R) and cooler check valve (S), then remove the main valve body (T) (three bolts). Do not let the check balls (U) fall out.
Remove the ATF pump driven gear shaft (V), then remove the ATF pump gears (W).
Remove the main separator plate (X) and two dowel pins (Y).
Remove the ATF magnet (Z), clean and reinstall it in the torque converter housing (AA).
Remove the O-ring (BB) from the stator shaft, and remove the O-ring (CC) from the ATF strainer. Install new ones when installing the valve bodies.
Clean the inlet opening (A) of the ATF strainer (B) thoroughly with compressed air, then check that it is in good condition and that the inlet opening is not clogged.
Test the ATF strainer by pouring clean ATF through the inlet opening, and replace it if it is clogged or damaged.
Heater Unit - Core Replacement Part-1
SRS components are located in this area.
Review the SRS component locations
and
the precautions and procedures
before doing repairs or service.
Do the battery t ...
Controls
This chapter explains how to operate the various controls necessary for
driving. ...
Intermediate Shaft Reassembly (A/T)
Exploded View
Special Tools Required
Oil Seal Driver, 65 mm 07JAD-PL90100
Bearing Driver Attachment, 52 x 55 mm 07746-0010400
Bearing Driver Attachment, 35 mm I.D. 07746-0030400
Driver ...