Honda Fit: Paddle Shifter (Downshift Switch) Replacement (A/T)
SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.
-
Remove the steering wheel.
-
Remove the four screws (A) securing the steering wheel rear cover (B), then remove the steering wheel rear cover.
-
Remove the paddle shifter пјЌ (downshift switch) connector (A) from its holder, and disconnect the connector.
-
Remove the screws (B) securing the paddle shifter пјЌ (C), and remove the paddle shifter пјЌ.
-
Install a new paddle shifter пјЌ on the steering wheel, and secure it with the screws.
-
Connect the paddle shifter пјЌ connector securely, and install the connector in the connector holder.
-
Install the steering wheel rear cover.
-
Install the steering wheel.
See also:
Windshield Replacement
NOTE:
Put on gloves to protect your hands.
Wear eye protection while cutting the glass adhesive with a piano wire.
Use seat covers to avoid damaging any surface.
Glass a ...
Rear Door Latch Replacement
NOTE:
Put on gloves to protect your hands.
Take care not to scratch the door or related parts.
Raise the glass fully.
Remove the door panel.
Disco ...
Transmission End Cover Transmission Fluid Pressure Switch Replacement (A/T)
Remove the transmission fluid pressure switch A (2nd clutch) (A).
Make sure there is no water, oil, dust, or foreign particles inside the
connector.
Install the new tr ...
Categories
