Special Tools Required
Install the mainshaft bearing (A), the countershaft bearing (B), the secondary shaft bearing (C), and the idler gear shaft bearing (D) in the transmission housing in the direction shown.
Expand each snap ring with the snap ring pliers, and install the bearing part-way into the housing.
Release the pliers, then push the bearing down into the housing until the snap ring snaps in place around it.
After installing the bearings verify that the snap rings (A) are seated in the bearing and housing grooves, and that the ring end gaps (B) are:
0 - 7 mm (0 - 0.28 in ) for all of the snap rings except the secondary shaft bearing on '12 - 13 models.
0 - 9 mm (0 - 0.35 in) for the secondary shaft bearing on '12 - 13 models.
Install the idler gear shaft (A) in the idler gear shaft bearing.
Install the cotters (B) and cotter retainer (C), and secure the idler gear shaft with the snap ring (D).
Fuel Tank Replacement
Drain the fuel tank until it is less than half full.
Reinstall the fuel tank unit without connecting the fuel tank unit 4P
connector and the quick-connect fitting (feed l ...
Safety of Infants and Small Children
Protecting Infants
An infant must be properly restrained in a rear-facing, reclining child seat
until the
infant reaches the seat maker’s weight or height limit for the seat, and the
infant is ...
Wheel Speed Sensor Replacement
Front
Turn the ignition switch to LOCK (0).
Remove the grommet (A), then disconnect the wheel speed sensor connector
(B).
@font-face{font-famil ...