Honda Fit manuals

Honda Fit: A/T Countershaft Reverse Selector Hub Installation (A/T)

Special Tools Required

  1. Install 1st gear, 2nd gear, 3rd gear, the 33.2 x   40 x 26 mm   collar, the 29 mm cotters, and the 33 x 45 x 7.8 mm   collar on the countershaft, and secure them with the snap ring.

  1. Install the needle bearings and the 4th-5th gear.

  1. Slide the reverse selector hub (A) over the countershaft (B), then press it in place using the driver handle (40 mm I.D.)   and a press.

    NOTE: Some reverse selector hubs are not press-fitted, and can be installed without using the a press.

See also:

Navigation
This section describes how to enter a destination, select a route to take, and follow the route to your destination. It also describes how to change your route or destination along the way. ...

Transmission Range Switch Replacement (A/T)
Raise the vehicle on a lift, or apply the parking brake, block the rear wheels, and raise the front of the vehicle. Make sure it is securely supported. Shift to N. ...

Before Driving
Before you begin driving your vehicle, you should know what gasoline to use and how to check the levels of important fluids. You also need to know how to properly store luggage or packages. The in ...

© 2022 Copyright www.hfitinfo.com