Honda Fit: Torque Converter Housing Selector Control Shaft Oil Seal Replacement (A/T)
Special Tools Required
- Driver Handle, 15 x 135L 07749-0010000
- Oil Seal Driver Attachment 07947-ZV00100
-
Remove the oil seal from the torque converter housing.
-
Install the new oil seal (A) in the torque converter housing to a depth (B) of 0.5пјЌ1.5 mm (0.02пјЌ0.06 in) below the housing surface using the driver handle and the oil seal driver attachment.
See also:
Immobilizer System Description
The vehicle is equipped with a Type VII immobilizer system that disables the
vehicle unless a programmed ignition key is used.
This system consists of a transponder combined with a keyless transmit ...
Dust and Pollen Filter Replacement
Open the glove box. Remove the glove box stop on each side, then
let the glove box hang down.
Pull the dust and pollen filter assembly (A) out from the blower unit.
...
Tailgate Lock Cylinder Replacement
For Some Models
NOTE: Put on gloves to protect your hands.
Remove the tailgate lower trim panal.
Disconnect the tailgate cylinder rod (A).
NOTE: Check for damaged or stress-wh ...
Categories
