Special Tools Required
Remove the mainshaft bearing and oil seal using the adjustable bearing puller (20пјЌ40 mm) and a commercially available 3/8 ''-16 slide hammer (A).
Install the new mainshaft bearing until it bottoms in the torque converter housing using the driver handle and the bearing driver attachment (62 x 68 mm).
Install the new oil seal flush with the housing using the driver handle and the bearing driver attachment (72 x 75 mm).
Manual Transmission
Release the parking brake.
Shift the transmission to neutral.
Leave the ignition switch in ACCESSORY (I) so the steering wheel does not
lock.
Make sure all accessories ar ...
Opening the Hood
1. Park the vehicle on a level surface, and set
the parking brake.
2. Pull the hood release handle under the
lower left corner of the dashboard.
► The hood will pop up slightly.
3. Push ...
Wheel Speed Sensor Replacement
Front
Turn the ignition switch to LOCK (0).
Remove the grommet (A), then disconnect the wheel speed sensor connector
(B).
@font-face{font-famil ...