Honda Fit: Transmission End Cover ATF Feed Pipe Replacement (A/T)
-
Remove the snap ring (A), the 3rd clutch feed pipe (B), and the feed pipe flange (C) from the end cover (D).
-
Install a new O-ring (E) over the 3rd clutch feed pipe.
-
Install the 3rd clutch feed pipe in the end cover by aligning the feed pipe tabs (F) with the indentations in the end cover.
-
Install a new O-ring (G) in the end cover, then install the feed pipe flange over the 3rd clutch feed pipe.
-
Secure the 3rd clutch feed pipe and the feed pipe flange with the snap ring.
-
Remove the snap ring (H) and the feed pipe flange (I).
-
Check the 4th clutch feed pipe (J) and the 2nd clutch feed pipe (K) for scoring and damage. Replace the end cover, if the feed pipe is scored or damaged.
-
Install a new O-ring (L) over the 4th clutch feed pipe.
-
Install a new O-ring (M) in the end cover, then install the feed pipe flange over the 4th clutch feed pipe.
-
Secure the 4th clutch feed pipe and the feed pipe flange with the snap ring.
See also:
Steering Angle Sensor Replacement
SRS components are located in this area. Review the
SRS component locations and the
precautions and procedures.
NOTE: Do not damage or drop the combination switch as the steering angle ...
Engine Number
@font-face{font-family:
"Honda_SymbolMarkeng";src:url(/statics/ho_prod_2/txt/Honda_SymbolMark_enu3.txt);}@font-face{font-family:
"Honda_Sp ...
Adjusting the Mirrors
Keep the inside and outside mirrors clean and
adjusted for best visibility.
Adjust the mirrors before you start driving. ...
Categories
