Honda Fit: ATF Lines

See also:

Secondary Shaft Disassembly, Inspection, and Reassembly (A/T)
Inspect the thrust needle bearings and the needle bearings for galling and rough movement. Inspect the splines for excessive wear and damage. Check the shaft bearing s ...

M/T Differential Thrust Clearance Adjustment (M/T)
Special Tools Required Driver Handle, 40 mm I.D. 07746-0030100 Remove the left driveshaft side oil seal from the transmission housing. If you remove the 80 mm shim (A) fro ...

CMP Pulse Plate Removal and Installation
Removal Remove the air cleaner. Remove the intake manifold chamber. Disconnect the following engine wire harness connectors, and remove the wire harness clamps ...