Honda Fit: Transmission End Cover Park Lever Stop Inspection and Adjustment (A/T)
-
Set the park lever in the P position.
-
Measure the center-to-center distance (A) between the park pawl shaft (B) and the park lever roller pin (C).
Standard:
37.8пјЌ38.8 mm (1.49пјЌ1.53 in)
-
If the measurement is out of standard, select and install the appropriate park lever stop (A) from the table.
PARK LEVER STOP
|
Mark |
B |
C |
|
1 |
11.00 mm |
11.00 mm |
|
2 |
10.80 mm |
10.65 mm |
|
3 |
10.60 mm |
10.30 mm |
-
After replacing the park lever stop, make sure the distance is within tolerance.
See also:
Pilot Bearing Replacement
Remove the crankshaft pilot bearing (A) using the remover weight (B), and
the 15 mm bearing remover shaft set (C).
Install a new pilot bearing (A) into the crankshaft using th ...
Cellular Phone Commands
The system accepts these commands only
on the PHONE screen.
Redial
Call History
Phonebook
Dial
Phone Setup
Phone Menu
Speed Dial 1
Speed Dial 2
More Speed Dial Lists
These commands can be m ...
Headlight Bulbs
When replacing, use the following bulbs.
High/Low beam headlight: 60/55 W (HB2)
NOTICE
Halogen bulbs get very hot when lit.
Oil, perspiration, or a scratch on the glass can cause
the bulb to ov ...
Categories
