Honda Fit: Secondary Shaft Disassembly, Inspection, and Reassembly (A/T)
-
Inspect the thrust needle bearings and the needle bearings for galling and rough movement.
-
Inspect the splines for excessive wear and damage.
-
Check the shaft bearing surface for scoring and excessive wear.
-
Before installing the O-rings, wrap the shaft splines with tape to prevent O-ring damage.
-
Lubricate all parts with ATF during assembly.
-
Install the conical spring washer, the idler gear, and the 31 x 50 mm thrust washer in the direction shown.
-
Replace the locknut and the conical spring washer with new ones when assembling the transmission. The locknut has left-hand threads.
-
Check the axial clearance of 1st gear and 2nd gear.
-
Inspect the condition of the sealing rings. If the sealing rings are worn, distorted, or damaged, replace them.
See also:
Brake Master Cylinder Inspection
Remove the master cylinder.
Inspect and note these items:
Before reassembling, check that all parts are free of dirt and other
foreign particles.
Do not t ...
Storing Your Home Address
1 Press the INFO button.
2 Select Setup.
3 Select Personal Information.
4 Select Home Address 1.
5 Select Edit Name.
6 Enter a name and select OK.
7 Select Edit Address.
8 Select ...
Piston Installation
If the Crankshaft is Already Installed
Set the crankshaft to bottom dead center (BDC) for each cylinder as its
piston is installed.
Remove the connecting rod caps, and check that ...
Categories
