Honda Fit manuals

Honda Fit: Clutch Disassembly (A/T)

Special Tools Required

  1. Remove the snap ring with a screwdriver.

  1. Remove the clutch end-plate (A), the clutch discs (B) (6), the clutch wave-plates (C) (6), and the wave spring (D) from the 1st clutch drum (E).

  1. Remove the clutch end-plate (A), the clutch discs (B) (3), the clutch flat-plates (C) (3), and the wave spring (D) from the 2nd clutch drum (E).

  1. Remove the clutch end-plate (A), the clutch discs (B) (4), the clutch flat-plates (C) (4), and the wave spring (D) from the 4th clutch drum (E).

  1. Remove the clutch end-plate (A), the clutch discs (B) (3), the clutch wave-plates (C) (3), and the wave spring (D) from the 4th clutch drum (E).

  1. Remove the clutch end-plate (A), the clutch discs (B) (3), the clutch wave-plates (C) (3), and the wave spring (D) from the 5th clutch drum (E).

  1. Install the clutch spring compressor set.

  1. Set the clutch spring compressor attachment (A) on the 1st clutch spring retainer (B) so the clutch spring compressor attachment works on the clutch return spring (C).

  1. If either end of the clutch spring compressor attachment is not set over the clutch return spring end, the spring retainer may be tilted and damaged. If the retainer is tilted when compressing the return spring, reset the clutch spring compressor attachment on the retainer at another range.

  1. Be sure the clutch spring compressor attachment (A) is adjusted to have full contact with the spring retainer (B) on the 2nd, 3rd, 4th, and 5th clutches, and set either end of the spring compressor attachment over the clutch return spring end.

  1. Check the placement of the clutch spring compressor attachment. If either end of the clutch spring compressor attachment is set over an area of the spring retainer that is unsupported by the return spring, the spring retainer may be damaged.

  1. Compress the return spring until the snap ring can be removed.

  1. Remove the snap ring with snap ring pliers.

  1. Remove the clutch spring compressor set.

  1. Remove the snap ring (A), the spring retainer (B), and the return spring (C).

  1. Wrap a shop rag around the clutch drum, and apply air pressure to the fluid passage to remove the piston. Place a finger tip on the other passage while applying air pressure.

  1. Remove the clutch piston (A) from the clutch drum (B) of the 1st, 2nd, and 4th clutches. Remove the O-ring   (C) from the clutch piston, and O-ring (D) from the drum.

  1. Remove the clutch piston (A) from the clutch drum of the 3rd and 5th clutches, and remove the outer O-ring (B) and inner O-ring (C) from the piston.

See also:

Floor Mats
If you remove a floor mat, make sure to re-anchor it when you put it back in your vehicle. A non-Honda floor mat may not fit your vehicle properly. This could prevent the proper operation of th ...

Wheel Bearing Replacement
Separate the hub (A) from the knuckle (B) using the hub dis/assembly tool and a hydraulic press. Hold the knuckle with the attachment (C) of the hydraulic press or equivalent tool. Be care ...

A/T System Description - Hydraulic Controls (A/T)
Hydraulic ControlsThe valve body includes the main valve body, the regulator valve body, and the servo body. The ATF pump is driven by splines on the end of the torque converter which is atta ...

© 2024 Copyright www.hfitinfo.com