Remove the snap ring (A), the cotter retainer (B), and the cotters (C) from the idler gear shaft (D), then remove the idler gear shaft. Do not distort the snap ring.
Check the snap ring and the cotter retainer for wear and damage. Replace the snap ring and/or the cotter retainer if the snap ring or the cotter retainer is worn, distorted, or damaged.
Install the idler gear shaft in the idler gear shaft bearing.
Install the cotters and cotter retainer, and secure the idler gear shaft with the snap ring.
Refilling Window Washer Fluid
Models without washer level sensor
Check the amount of window washer fluid. Look for 1/2 mark on the reservoir.
If the level is low, fill the washer reservoir.
Models with washer level senso
If ...
Off-road Tracking
INFO button
► Setup ►Other
►Vehicle
The navigation system can be set to display white off-road tracking dots
(“breadcrumbs”) on the map screen whenever you drive into an are ...
Shift Lever Does Not Move
Automatic transmission models
Follow the procedure below if you cannot move the shift lever out of the
position.
■Releasing the Lock
1. Set the parking brake.
2. Remove the key from the ...