Remove the final driven gear (A) from the differential carrier (B). The final driven gear bolts have left-hand threads.
Install the final driven gear on the differential carrier in the direction shown.
Tighten the bolts to 101 NВ·m (10.3 kgfВ·m, 74.5 lbfВ·ft) in a crisscross pattern in at least two steps.
A/F Sensor Replacement
Special Tools Required
O2 Sensor Wrench Snap-on S6176 or equivalent, commercially available
Remove the cowl cover and the under-cowl panel.
Disconnect the A/F se ...
Engine Number
@font-face{font-family:
"Honda_SymbolMarkeng";src:url(/statics/ho_prod_2/txt/Honda_SymbolMark_enu3.txt);}@font-face{font-family:
"Honda_Sp ...
M/T Differential Thrust Clearance Adjustment (M/T)
Special Tools Required
Driver Handle, 40 mm I.D. 07746-0030100
Remove the left driveshaft side oil seal from the transmission housing.
If you remove the 80 mm shim (A) from ...