Honda Fit manuals

Honda Fit: Throttle Body Cleaning

caution

Do not insert your fingers into the installed throttle body when you turn the ignition switch to ON (II) or while the ignition switch is in ON (II). If you do, you will seriously injure your fingers if the throttle valve is activated.

  1. Make sure the ignition switch is turned to LOCK (0).

  1. Check for damage to the air cleaner. If the air cleaner is damaged, replace it.

  1. Remove the throttle body.

  1. Clean off the carbon from the throttle valve and inside the throttle body with a paper towel soaked in throttle plate cleaner.

    NOTE:

    • Always remove the throttle body to clean it.

    • Be careful not to pinch your fingers.

    • To avoid removing the molybdenum coating, do not clean the bearing area of the throttle shaft (A).

    • Do not spray throttle plate cleaner directly on the throttle body.

    • Use Honda genuine throttle plate cleaner.

  2. Reinstall the throttle body.

  1. Connect the HDS to the data link connector (DLC) (A) located under the driver's side of the dashboard.

  1. Turn the ignition switch to ON (II).

  2. Reset the ECM/PCM with the HDS.

  3. Select the ETCS TEST in the INSPECTION MENU with the HDS.

  4. Select the TP POSITION CHECK, then clear the throttle position (TP) learned value.

  5. Turn the ignition switch to LOCK (0).

  6. Turn the ignition switch to ON (II), and wait 2 seconds   without pressing the accelerator pedal.

  7. Do the ECM/PCM idle learn procedure.

See also:

Power Windows
Turn the ignition switch to the ON (II) position to raise or lower any window. To open the window, push the switch down and hold it. Release the switch when you want to stop the window. To close ...

Exterior Care
Dust off the vehicle body after you drive. Regularly inspect your vehicle for scratches on painted surfaces. A scratch on a painted surface can result in body rust. If you find a scratch, promptly ...

A/T Differential Carrier and Final Driven Gear Replacement (A/T)
Remove the final driven gear (A) from the differential carrier (B). The final driven gear bolts have left-hand threads. Install the final driven gear on the differential carri ...

© 2024 Copyright www.hfitinfo.com