Honda Fit: A/T Housing Idler Gear Shaft Removal and Installation (A/T)
-
Remove the snap ring (A), the cotter retainer (B), and the cotters (C) from the idler gear shaft (D), then remove the idler gear shaft. Do not distort the snap ring.
-
Check the snap ring and the cotter retainer for wear and damage. Replace the snap ring and/or the cotter retainer if the snap ring or the cotter retainer is worn, distorted, or damaged.
-
Install the idler gear shaft in the idler gear shaft bearing.
-
Install the cotters and cotter retainer, and secure the idler gear shaft with the snap ring.
See also:
A/T Housing Reverse Idler Gear Installation (A/T)
Lightly coat the reverse idler gear shaft (A), the needle bearing (B),
and new O-rings (C) with lithium grease.
Assemble the new O-rings and the needle bearing on the reverse ...
Clutch Clearance Inspection (A/T)
Special Tools Required
Clutch Compressor Attachment 07ZAE-PRP0100
Inspect the clutch piston, the discs, the plates, and the end-plate for
wear and damage, and inspect the clutch wav ...
Changing Your Destination
There are several methods you can use to change the route destination. ...
Categories
